top of page
For the re-wrapping of welds and fittings on pipelines as corrosion protection coating
1/1
PALIMEX KS 200 and KS 220 – Two-band system for corrosion protection coating according to DIN 30672 and DIN EN 12068 for pipes in soils and waters with operating temperatures up to 50 °C. At high corrosive and high mechanical loads.
PALIMEX K 100 and K 90 – Two-band system for corrosion protection coating according to DIN 30672 and DIN EN 12068 for pipes in soils and waters with operating temperatures up to 30 °C. At high corrosive and high mechanical loads.
1/1
1/1
PALIMEX KS 140 - Cover system for corrosion protection coating according to DIN 30672 and DIN EN 12068 for pipes in soils and waters with operating temperatures up to 50 °C. At high corrosive and high mechanical loads.
System solution for the corrosion-critical area of the floor/air transitions of steel pipes
1/1
1/1
Stable filler mass with high adhesion for filling all unevenness on metal surfaces.
​
Repair of damage to the factory envelope. Compensation of all recesses and webs for flanges, sockets, sliders and couplings.
Only PALIMEX PRIMER K 125 should be used as a liability ground for PALIMEX corrosion protection tapes, as it is a component of all PALIMEX systems registered with the DVGW.
1/1
1/1
With the hand-held winding device, the cold-processable PALIMEX corrosion protection tapes can be wrapped around pipes and bows with uniform winding voltage and exact overlap width.
​
The winding device detects straight pipes from DN 80 to DN 1400, as well as all pigable elbows. Tapes up to 100 mm in width can be processed.
PALIMEX HK3-C is a two-component repair compound for corrosion protection coatings with strongly accelerated curing. The assembly in a double cartridge allows the simple, safe and needs-based mixing.
​
The mass cures pore-free and forms an electrically highly insulating coating. The cured material is impact-resistant, impressive and resists high tensile shear loads.
1/1
1/1
PALIMEX TLC is a two-component filler compound applied to the weld area of
steel pipes in the layer thickness of the adjacent factory coating.
​
PALIMEX TLC is processed in two operations and reaches electrical tightness immediately after curing. The filler is non-flammable and is hardened by propane flame in a few minutes.
for complicated contours of piping fittings and correspond to load class A 30 according to DIN 30672 and DIN EN 12068.
​
The strip consists of a special man-made fibre fleece coated on both sides with a petroleum mass. The special feature consists of a one-sided elastic plastic film, which prevents the removal and washing out by groundwater.
1/1
1/1
for cavity-free filling of indentations and flange gaps on piping components as preparation for applying the PALIMEX F 30 belts in an angular or tapestry process.
​
The filling compound based on petrolatum is interspersed with styrofoam balls. This creates a stable backfilling and no sagging as with usual filling masses. In addition, the Mastic PF is easier to process at low temperatures.
bottom of page